|
RefSetType
|
It is possible to choose between certain additional
types/arrangements:
- single point
- polygon
- curve
- stress-check point
- temperature point
- perimeter polygon
point
- perimeter curve
point
- line begin or end
point
Additionally can be set a point, for which the
stress check will be done.
|
|
Pnt name
|
The points can be named (max. 16 char)
|
|
Attribute-Set
|
An attribute-set (material) can be assigned to each item of
additional point.
If the attribute set is not input, the values for
reinforcement material are zero!If the Attribute set for stress check point is
not input, the first combination of max/minstress values from material file
will be accepted (condition: element has to beassigned to a certain material
from the table!).
|
|
EDGES
|
Each point must be assigned to two cross-section edges. The input
of nodes distance and angle is necessary for each point.
|
|
NODE 1
|
Input the cross-section node numbers for the first and second
edges defining the first additional point
|
|
NODE 2
|
Input the cross-section node numbers for the first and second
edges defining the second additional point
|
|
DISTANCE
|
Distance of the additional point from the first/second edge,
measured in the direction defined by the angle - see input below.
|
|
ANGLE
|
Direction (Angle) between the edge and the additional point.
|
|
TMP
|
For temperature points the temperature gradient must be input.
|
| Store Stress leading results for this point
|
To store the stress results in different points as leading
component, user need to enable "Store Stress Leading Results for This Point"
and select normal or shear stresses for desired points.
|
